Soldering #1 connector on logic board
Page 1 of 1

Author:  brap999 [ Wed Feb 22, 2012 10:36 pm ]
Post subject:  Soldering #1 connector on logic board

I have an old iphone 3gs, with the #1 connector on the motherboard missing. Normally it would be straight forward to solder a new connector on to it, however if you look at the attached photo you'll notice that some of the connection points are missing.

I'm more of a software guy than a electronics engineer, so this kind of repair is new to me. What is needed to be done to get the solder connection points back on the board?

I realize this may be more of a general pcb repair question, but I've been searching and I guess I just don't know exactly what to search for to the correct answer.

Any help from you hardware guys would be greatly appreciated

Author:  justin-pbmedic [ Thu Feb 23, 2012 3:11 pm ]
Post subject:  Re: Soldering #1 connector on logic board

It wouldn't be feasible at that point to get it repaired. I'd just replace it.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group