Easy Search [ ? ]
 
* Login   * Register * FAQ    * Search

View unanswered posts | View active topics


Board index » Powerbook G4 Discussions » Aluminum G4

All times are UTC - 6 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 
  Print view Previous topic | Next topic 
Author Message
Amy
 Post subject: Screws will not BUDGE! PBG4 17" HELP Trying to replace
PostPosted: Sat Feb 09, 2008 2:00 pm 
I'm trying to replace the superdrive in my aluminum powerbook g4 17 inch. I started to take it apart and everything was going fine and dandy until I reached 3 screws at the bottom back edge...

Image

The 3 in the middle will not move.

Any suggestions?

Thanks,
Amy:)
Top
  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 

Board index » Powerbook G4 Discussions » Aluminum G4

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
 
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group